Hawkeye firefly Thumb 3 firmware 20250905
Update List:
Add gyro calibration.
When EIS set to OFF, then set to rocksteady/horizontal/LFOV, the calibration will work, please keep it state horizontal level.
Firmware download:
https://drive.google.com/drive/folders/1DngQbg2_fmr7AI3Yhtzvh_affPuw0SZF?usp=sharingHow to update:
1.Use a 8-32G tf card, format it to fat32 on computer.
2.Download the 2 firmware files to sd card root dirctory .
3.Put the sd card into camere(make sure battery > 50%).
4.Power on the camera and it will update firmware automatically.
5.When updating, the Red LED will flash(Very very fast, when you colse to it, you can feel that) it takes about 23 seconds, Don't power off when updating, or it will....die.
6.When update finish camera will reboot ,beeeps and LED turn Blue, delete the 2 firmware files.
7.Format SD card in APP to run the camera fast(if tf card format worong, boot up will be slow).
Youtube tutorial :https://youtu.be/36fSIRs1pzE?si=M_2MWCkv7TRnb3qB
更新列表：
增加地平线校正。
陀螺仪（EIS)关闭到开启时，自动进行校正，请平放相机。
固件下载：
链接：https://pan.baidu.com/s/1c0o9gPq4pM5dYuW3waL4YA?pwd=HAWK
提取码：hawk
更新方法：
1.使用8-32G TF卡，将SD卡在电脑上格式话为 -> fat32 .
2.下载2个固件文件到 SD 卡上根目录 如下所示：
3.将tf卡放到机器里面.
4.重新开机（注意电池必须保证电量>50%).
5.更新过程中，红色LED灯会闪烁(非常快速，闪的超快，靠近距离看能感受到，此时在刷新),更新过程需时20多秒，更新过程请勿关机，否者....会成砖.
6.更新完成后，机器蜂鸣器会响，LED变成蓝色，升级后删掉升级文件.
7.升级后，需要在APP重新格式化tf卡（如果开机速度慢时，是因为tf卡格式不对）。
Hawkeye firefly Thumb 3 firmw
Hawkeye firefly Thumb 3 firmw
Hawkeye firefly Thumb 3 firmw
Hawkeye firefly Thumb 3 firmw